1.Gas detector selection point should be selected valve, pipe interface, outlet or easy to leak near the radius of 1 meter range, as close as possible, but do not affect other equipment operation, while avoiding high temperature, high humidity environment, to avoid the external Affect the possibility of splashing water, oil and causing mechanical damage.
2.Gas detection probe installation can be used roof roofing, wall installation or pipe installation, should ensure that the installation of solid and reliable, should be considered easy to maintain, calibration.
3.Gas alarm wiring should be used three-core shielded cable, a single wire diameter greater than 1 square millimeter, wiring shield must be grounded.
4.The gas detector should be installed with the sensor facing down. The locking nut should be tightened completely. The probe cover should be completely covered and tightened with screws to meet the explosion protection requirements.
5.Gas alarm should be wired in the case of power to determine the correct wiring after the power; should be determined in the scene without gas leakage, open the lid debugging probe.
6.The gas detector should be installed in a position where there is no large vibration and the temperature is as stable as possible.
7.The gas detector should be calibrated at least once a year to ensure detection accuracy. Probe prohibits pure gas test, is strictly prohibited smoked with a lighter, so as to avoid the probe due to the concentration of combustible smoked and premature failure.
8.Gas detector from the hands of the user from the time, the warranty for one year after the warranty period, the company can provide paid services. Due to improper use of the user damage caused by the probe is not within the scope of the warranty, depending on the cost of the cost of nuclear processing, repair or replacement.